Pixelink Support

Linux SDK Troubleshooting

Camera is not Detected in captureOEM
If a PL-D camera is connected to a host system, but cannot be detected in captureOEM after installing the Linux SDK, check the following: 1. Run the &qu...
Mon, 17 Sep, 2018 at 3:53 PM
Camera is Detected but Cannot Stream
Cause: The USB3 bus power provided by the ARM board is not sufficient to power the camera. Solution: Power the USB3 camera using a powered USB3.0 hub.
Thu, 22 Mar, 2018 at 5:05 PM
Image Transfer Fails to Start when Image Size is Bigger than 2 MB
Cause: The USBFS buffer size is too small (16 MB by default). The following command can be used to check usbfs_memory_mb size.      cat /sys/module/...
Mon, 15 Oct, 2018 at 3:31 PM